Specifications

SENSe Subsystem
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Node
9-14 Agilent E4418B/E4419B Programming Guide
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Node
This node is used to select the active sensor calibration table and the
active frequency dependent offset table.
Note If any of the CSET1 commands are used when an Agilent E-series
power sensor is connected, the error -241, “Hardware missing”
occurs.
The commands associated with this node are:
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2
[:SELect] <string>
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe
<Boolean>
prog.book Page 14 Thursday, June 7, 2001 2:55 PM