Specifications

Power Meter Remote Operation
Introduction
1-2 Agilent E4418B/E4419B Programming Guide
Introduction
This chapter describes the parameters which configure the power meter
and help you determine settings to optimize performance. It contains the
following sections:
“Configuring the Remote Interface”, on page 1-3.
“Zeroing and Calibrating the Power Meter”, on page 1-11.
“Making Measurements”, on page 1-14.
“Using Sensor Calibration Tables”, on page 1-30.
“Using Frequency Dependent Offset Tables”, on page 1-40
“Setting the Range, Resolution and Averaging”, on page 1-47.
“Setting Offsets”, on page 1-51.
“Setting Measurement Limits”, on page 1-53.
“Measuring Pulsed Signals”, on page 1-58.
“Triggering the Power Meter”, on page 1-61.
“Getting the Best Speed Performance”, on page 1-66.
“How Measurements are Calculated”, on page 1-70.
“Status Reporting”, on page 1-71.
“Saving and Recalling Power Meter Configurations”, on page 1-91.
“Using Device Clear to Halt Measurements”, on page 1-92.
“An Introduction to the SCPI Language”, on page 1-93.
“Quick Reference”, on page 1-102.
“SCPI Compliance Information”, on page 1-111.
prog.book Page 2 Thursday, June 7, 2001 2:55 PM