Specifications

MEASurement Instructions
CONFigure[1|2][:SCALar][:POWer:AC]:RELative [<expected_value>[,<resolution>[,<source list>]]]
2-12 Agilent E4418B/E4419B Programming Guide
Example
source list This is the channel on which the
command is implemented.
If unspecified the current window
setup is used. However, on the
Agilent E4419B, if the window
shows a ratio or difference
measurement, the upper window
defaults to channel A and the
lower window to channel B.
(@1)
(@2) (Agilent E4419B
only)
1. The mnemonic
DEF means DEFault. This is not equivalent to the DEFault
parameter used in the command sub-systems. The parameters must be entered in
the specified order. If parameters are omitted, they will default from the right.
The parameter DEFault is used as a place holder. Specifying
DEF leaves the
parameter value unchanged.
2. When the measurement result is linear this parameter represents the number
of significant digits. When the measurement result is logarithmic 1 to 4
represents a resolution of 1, 0.1, 0.01 and 0.001 respectively.
CONF2:REL -50DBM,3,(@1) This command configures the
lower window to measure the
relative power of channel A, using
an expected power level of -50 dBm
and a resolution setting of 3.
Item Description/Default Range of Values
prog.book Page 12 Thursday, June 7, 2001 2:55 PM