System information

© Agilent Technologies 2001–2003 Administering Agilent 3070 Systems (MS Windows NT and 2000) 4-26
Chapter 4: Backing Up and Restoring System Software
5 Insert the remaining Recovery Diskettes
when prompted.
NOTE
After completing these steps, it takes
approximately 30 minutes to one
hour to restore your system.
NOTE
Your system may automatically reboot several times after the
restart process.
a Insert Recovery Diskette 2, then press F10.
b When prompted, remove Recovery Diskette 2 and insert
Recovery Diskette 3, then press F10.
c When prompted, remove Recovery Diskette 3 and insert
Recovery Diskette 4, then press F10.
d Remove Recovery Diskette 4.
e Press F10 to reboot (restart) your system.
NOTE
When the system reboots, the disaster recovery software
should initialize and the recovery tape should begin to load.
The system may stop responding while displaying the
message Deinitializing System Support. If this occurs,
press the reset button to reboot the system. After the system
reboots, the disaster recovery process will continue and the
tape should begin to load.
Table 4-5 How to restore a system from a disaster using boot recovery diskettes and full backup tape (continued)
Task Step