System information

© Agilent Technologies 2001–2002 Administering Agilent 3070 Systems (MS Windows NT and 2000) 2-2
Chapter 2: Starting and Shutting Down the System
Starting the System This section describes how to start and boot a 3070 MS
Windows® controller and testhead.
■ Booting a 3070 Controller, 2-2
■ Logging In, 2-3
■ Booting the Testhead, 2-3
Prerequisites
Before beginning, your Agilent 3070 system must be
installed and set up correctly by an Agilent CE or SE.
Required Tools and Materials
■ Windows® 2000 Professional Quick Start Guide
■ A 3070 Testhead with Windows® 2000
Professional and software revision 3070 04.00pb
0501 WN or later.
Booting a 3070 Controller
1 Turn on the video display and any other
peripherals.
2 Turn on power to the controller.
3 Allow the controller to boot.
During the boot process, the system:
■ tests and initializes hardware components.
■ loads the operating system.
■ starts log on and other system services.
Read the messages displayed on the video monitor.
These messages could be important in solving system
administration problems.
The controller boot process is complete when the Log on
to Windows screen appears.
ADVICE
The first time you start your system, you will need
to enter information in the Windows 2000 Setup
Wizard. Follow the on-screen instructions and
refer to the Windows® 2000 Professional Quick
Start Guide.