Installation manual

Chapter 1: MS Windows System Installation Procedure: Tools Required

Tools Required These tools are needed in addition to the tools supplied

with the system shipment:

■ BNC-to-dual banana coaxial cable 11001-60001,

for Diagnostics,

■ BNC(F)-to-BNC(F) (barrel) connector

1250-0080, for Diagnostics,

■ Pin Verification Fixture (PVF) for Diagnostics:

• E3771B for one-module systems,

• E4033B for one to four-module systems,

• N4355A 2-Bank No-Wire Interface PVF (only

required with No-Wire fixture,)

■ T10 & T20 Torx drivers,

■ #2 Phillips or Posi screwdriver,

■ 1/4-inch flat blade screwdriver,

■ 5- and 10-mm hex key wrenches,

■ Diagonal-cutters to cut straps,

■ Utility knife to open boxes,

■ 7/16-inch and 9/16-inch, 3/8-inch square-drive

sockets,

■ 6-inch-long, 3/8-inch square-drive extension,

■ 3/8-inch square-drive ratchet,

■ Cordless drill – 14.4 Volt, 3/8-inch drill / driver

kit.