Technical data

Oscilloscope Familiarization Labs 2
3000 X-Series Oscilloscopes Advanced Training Guide 37
15 Press Statistics.
16 Press Reset Statistics to clear the statistics from the previous test.
17 Press the (Back) key.
18 Press Setup.
19 Press On Error – Stop two times.
20 Press [Run/Stop] to begin a new “Stop-on-Error” test.
In addition to stopping acquisitions when an error is detected as shown in
Figure 21, you can also save a waveform, save an image, print, or perform
specific measurements when an error is detected. Using the “Run Until”
selection, you can also set up mask testing to run for a specific number of
tests, minimum time, or minimum Sigma test criteria. Note that in
addition to creating a pass/fail mask using the auto- mask creation feature
as demonstrated in this lab, you can also import a mask based on industry
specifications, such as an eye- diagram mask, from a USB memory device.
These types of imported masks can be easily created within a standard
text editor, such as NotePad on your PC.
Figure 21 Establishing specific test criteria.
Back