Technical data

18 3000 X-Series Oscilloscopes Advanced Training Guide
2 Oscilloscope Familiarization Labs
33 Press the Type softkey; then turn the Entry knob until the arrow points
to Snapshot All (top of the list).
34 Now either press the Add Measurement softkey, or push the Entry knob
to add this set of measurements.
The “Snapshot-All” measurement provides us with a one- time (snapshot)
measurement of several parameters in order to completely characterize our
input signal as shown in Figure 7. Note that this set of measurements is
not continuously updated, and if you press any front panel or softkey, the
display of these measurements will disappear.
Figure 7 Performing a comprehensive set of automatic parametric measurements using
the “Snapshot All” function.