Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
8 Agilent 3000 Series Oscilloscopes User’s Guide
Contents
Setting Other Trigger Parameters 82
To set the trigger sweep 82
To set the trigger coupling 82
Using the External Trigger Input 83
Recording/Playing-back Waveforms 83
To record waveforms 83
To play-back waveforms 84
To store recorded waveforms 86
4 Making Measurements 87
Displaying Automatic Measurements 88
To display an automatic measurement 88
To clear automatic measurements from the display 89
To display or hide all automatic measurements 89
Voltage Measurements 90
Vpp (Peak-to-Peak Voltage) 90
Vmax (Maximum Voltage) 91
Vmin (Minimum Voltage) 91
Vavg (Average Voltage) 91
Vamp (Amplitude Voltage = Vtop - Vbase) 91
Vtop (Top Voltage) 91
Vbase (Base Voltage) 91
Vrms (Root-Mean-Square Voltage) 92
Overshoot 92
Preshoot 92