Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
3Capturing Data
76 Agilent 3000 Series Oscilloscopes User’s Guide
Adjusting the Trigger Level
To adjust the trigger level
• Turn the trigger Level knob.
Two things happen:
• The trigger level value is displayed at the lower left- hand corner of
the screen. If the trigger is DC coupled, it is displayed as a voltage.
If the trigger is AC coupled or LF reject coupled, it is displayed as a
percentage of the trigger range.
• A line is displayed showing the location of the trigger level with
respect to the waveform (except when using AC coupling or LF reject
coupling modes).
• Push 50%
to set the level at 50% of the signal’s vertical amplitude.
Figure 36 Trigger Controls
Trigger level knob