Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
6 Agilent 3000 Series Oscilloscopes User’s Guide
Contents
2 Displaying Data 35
Using the Horizontal Controls 36
To adjust the horizontal scale 38
To adjust the horizontal position 39
To display the delayed sweep time base 39
To change the horizontal time base (Y-T or X-Y) 40
To reset the trigger offset 42
To specify a trigger holdoff 42
To view the sample rate 43
Using the Vertical Controls 44
To turn waveforms on or off (channel, math, or reference) 45
To adjust the vertical scale 45
To adjust the vertical position 46
To specify channel coupling 46
To specify a bandwidth limit 48
To specify the probe attenuation 50
To use a digital filter 51
To invert a waveform 51
Using Math Function Waveforms 53
To add, subtract, or multiply waveforms 54
To display the frequency domain using FFT 54
Using a Reference Waveform 57
To save a reference waveform 57
To position, scale, and invert a reference waveform 57