Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
Displaying Data 2
Agilent 3000 Series Oscilloscopes User’s Guide 59
To use waveform persistence
1 Press Display.
2 In the Display menu, select Persist to toggle the waveform display
between:
• Infinite — sample points remain displayed until the display is cleared
or persistence is set to “OFF”.
• OFF.
To clear the display
1 Press Display.
2 In the Display menu, select Clear.
To adjust the display brightness
1 Press Display.
2 In the Display menu, select:
• — to increase the display brightness.
• — to decrease the display brightness.
To change the menu display time
The menu display time is how long menus remain on the screen after a
menu button has been pressed.
1 Press Display
.
2 In the Display menu, press Menu Display to select “1s”, “2s”, “5s”, “10s”,
“20s”, or “Infinite” menu display time.