Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
Displaying Data 2
Agilent 3000 Series Oscilloscopes User’s Guide 57
Using a Reference Waveform
You can save a reference waveform to an internal, nonvolatile memory
location and then display it on the oscilloscope along with other captured
waveforms.
Reference waveforms are displayed (that is, turned on/off) just like other
waveforms (see page 45).
To save a reference waveform
1 Press Ref.
2 In the Ref menu, press Source until the waveform you want to save is
selected.
3 Press Save.
4 To invert the reference waveform (with respect to the reference level),
select Invert to toggle between “ON” and “OFF”.
5 Use the remaining menu items and the Entry
knob to position and scale
the reference waveform.
To position, scale, and invert a reference waveform
1 Press Ref to turn on the reference waveform and access the Ref menu.
2 In the Ref menu:
• To invert the reference waveform (with respect to the reference
level), press Invert to toggle between “ON” and “OFF”.
• Use the remaining menu items and the Entry
knob to position and
scale the reference waveform.
NOTE
The reference waveform function is not available in X-Y mode.