Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
2 Displaying Data
48 Agilent 3000 Series Oscilloscopes User’s Guide
To specify a bandwidth limit
When high frequency components of a waveform are not important to its
analysis, the bandwidth limit control can be used to reject frequencies
above 20 MHz. See Figure 19 and Figure 20.
1 If the channel’s menu is not currently displayed, press the channel
button (1
, 2).
2 In the Channel menu, select BW Limit to toggle the bandwidth limit
setting “ON” and “OFF”.
Figure 18 GND Coupling Control
Ground Coupling
Ground Coupling Status