Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
2 Displaying Data
40 Agilent 3000 Series Oscilloscopes User’s Guide
To change the horizontal time base (Y-T or X-Y)
1 Press Main/Delayed.
2 In the Main/Delayed menu, press Time Base to select between:
• Y-T — Amplitude vs. time. This is the typical horizontal time base
setting.
• X-Y — Channel 2 (X- axis) vs. Channel 1 (Y-axis), see “X-Y Format”
on page 41.
Figure 12 Delayed Sweep Time Base Window
Zoomed window
Zoomed window view