Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
Getting Started 1
Agilent 3000 Series Oscilloscopes User’s Guide 33
Step 9. Use the Run Control buttons
There are two buttons for starting and stopping the oscilloscope’s
acquisition system: Run/Stop
and Single.
• When the Run/Stop
button is green, the oscilloscope is acquiring data.
To stop acquiring data, press Run/Stop
. When stopped, the last acquired
waveform is displayed.
• When the Run/Stop
button is red, data acquisition is stopped. To start
acquiring data, press Run/Stop
.
• To capture and display a single acquisition (whether the oscilloscope is
running or stopped), press Single
. After capturing and displaying a
single acquisition, the Run/Stop
button is red.
Figure 9 Run Control Buttons