Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
1Getting Started
30 Agilent 3000 Series Oscilloscopes User’s Guide
The oscilloscope is configured to the following default control settings:
Table 2 Auto-Scale Default Settings
Menu Setting
Horizontal time base Y-T
Sampling mode Real Time
Acquire mode Normal
Vertical coupling Adjusted to AC or DC according
to the waveform.
Vertical "V/div" Adjusted
Bandwidth limit OFF
Waveform invert OFF
Horizontal position Center
Horizontal "time/div" Adjusted
Trigger type Edge
Trigger source Measure the channel with
input waveform automatically.
Trigger coupling DC
Trigger level Midpoint setting
Trigger sweep Auto