Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
1Getting Started
22 Agilent 3000 Series Oscilloscopes User’s Guide
Step 3. Load the default oscilloscope setup
You can recall the factory default setup any time you want to return the
oscilloscope to its original setup.
1 Press the Save/Recall
button.
2 In the Save/Recall menu, press the Storage menu button until “Setups”
is selected.
3 Press the Default Setup menu button.
Figure 2 Save/Recall Button