Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
Agilent 3000 Series Oscilloscopes User’s Guide 13
Figures
Figure 1. Package Contents 19
Figure 2. Save/Recall Button 22
Figure 3. Front Panel 24
Figure 4. Menu Buttons 26
Figure 5. Oscilloscope Display 28
Figure 6. Auto-Scale Button 29
Figure 7. Low Frequency Probe Compensation 31
Figure 8. High Frequency Probe Compensation 32
Figure 9. Run Control Buttons 33
Figure 10. Horizontal Controls 36
Figure 11. Status Bar, Trigger Position, and Horizontal Scale Indicators 37
Figure 12. Delayed Sweep Time Base Window 40
Figure 13. X-Y Display Format Showing In-Phase Waveforms 41
Figure 14. Trigger Holdoff 42
Figure 15. Vertical Controls 44
Figure 16. DC Coupling Control 47
Figure 17. AC Coupling Control 47
Figure 18. GND Coupling Control 48
Figure 19. BW Limit Control ON 49
Figure 20. BW Limit Control OFF 49
Figure 21. Probe Attenuation Set to 1000:1 50
Figure 22. Waveform Before Inversion 52
Figure 23. Waveform After Inversion 52
Figure 24. Math Scale Setting Value 53
Figure 25. FFT Waveform 56
Figure 26. Display Button 58
Figure 27. Alaising 63
Figure 28. Theoretical Brick-Wall Frequency Response 64