Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
8Service
128 Agilent 3000 Series Oscilloscopes User’s Guide
Testing Performance
This section documents performance test procedures. Performance
verification for the products covered by this manual consists of three main
steps:
• Performing the internal product self- tests to ensure that the
measurement system is functioning properly.
• Calibrating the product.
• Testing the product to ensure that it is performing to specification.
Performance Test
Interval
The procedures in this section may be performed for incoming inspection
and should be performed periodically to verify that the oscilloscope is
operating within specification. The recommended test interval is once per
year or after 2000 hours of operation. Performance should also be tested
after repairs or major upgrades.
Performance Test
Record
A test record form is provided on page 144. This record lists performance
tests, test limits and provides space to record test results.
Test Order The tests in this section may be performed in any order desired. However,
it is recommended to conduct the tests in the order presented in this
manual as this represents an incremental approach to performance
verification. This may be useful if you are attempting to troubleshoot a
suspected problem.
Test Equipment Lists of equipment needed to conduct each test are provided for each test
procedure. The procedures are written to minimize the number and types
of oscilloscopes and accessories required. The oscilloscopes in these lists
are ones that are currently available for sale by Agilent at the time of
writing this document. In some cases, the test procedures use features
specific to the oscilloscopes in the recommended equipment list. However,
with some modification to the test procedures, oscilloscopes, cables and
accessories that satisfy the critical specifications in these lists may be
substituted for the recommended models with some modification to the
test procedures.
Contact Agilent Technologies (see page 146) for more information about
the Agilent products in these lists.