Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
Oscilloscope Utility Settings 6
Agilent 3000 Series Oscilloscopes User’s Guide 115
Setting IO Parameters
When programming the oscilloscope over the RS- 232 interface, the baud
rate must match on the oscilloscope and the controller PC’s RS- 232 port.
To set the RS- 232 interface baud rate:
1 Press Utility
.
2 In the Utilities menu, select IO Setup.
3 In the I/O Setup menu, press RS-232 Baud to select the desired baud
rate.
For more on programming the oscilloscope, see the 3000 Series
Oscilloscopes Programmer’s Guide.
Setting the Menu Language
To set the language used in menus:
1 Press Utility
.
2 In the Utilities menu, press Language to select the desired menu
language.
You can select from the following languages:
• Simplified Chinese.
• Traditional Chinese.
• Korean.
• Japanese.
• English.
• German.
• French.
• Portuguese.
• Spanish.
• Italian.
• Russian.