Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
6 Oscilloscope Utility Settings
112 Agilent 3000 Series Oscilloscopes User’s Guide
Performing Mask Tests
The mask test function monitors waveform changes by comparing the
waveform to a predefined mask.
To access the Mask Test menu:
1 Press Utility
.
2 In the Utilities menu, select Mask Test.
To enable/disable mask tests
1 In the Mask Test menu (Utility→Mask Test), select Enable Test to toggle
between OFF and ON.
To select the source channel for mask tests
1 In the Mask Test menu (Utility→Mask Test), press Source to select the
desired input channel.
To run/stop a mask test
1 In the Mask Test menu (Utility→Mask Test), select Operate to run or stop
the test.
• — Appears on the menu when the test is stopped; press Operate to
run the test.
• — Appears on the menu when the test is running; press Operate to
stop the test.
NOTE
The Mask Test function is not available in the X-Y horizontal timebase mode.