Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
Saving, Recalling, and Printing Data 5
Agilent 3000 Series Oscilloscopes User’s Guide 105
For information on using the Save menu, see “To save a file to a USB
device” on page 106.
For information on using the Load menu, see “To load a file from a
USB device” on page 108.
To save/load oscilloscope setups to/from a USB device
You can save/load setups to an external USB drive when it is connected to
the USB host port.
1 Press Save/Recall
.
2 In the Save/Recall menu, press Storage until “USB” is selected.
3 Press File Type until “Setup” is selected.
4 Press Save or Load.
For information on using the Save menu, see “To save a file to a USB
device” on page 106.
For information on using the Load menu, see “To load a file from a
USB device” on page 108.
To save screens to BMP format files (on a USB device)
You can save oscilloscope display screens (in BMP format) to an external
USB drive when it is connected to the USB host port.
1 Press Save/Recall
.
2 In the Save/Recall menu, press Storage until “USB” is selected.
3 Press File Type until “Bit map” is selected.
4 Press Bmp Format to select between 24- bit and 8- bit.
5 Press Save.
For information on using the Save menu, see “To save a file to a USB
device” on page 106.