Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
Saving, Recalling, and Printing Data 5
Agilent 3000 Series Oscilloscopes User’s Guide 103
To save and load oscilloscope setups
You can save/load oscilloscope setups to/from 10 internal, nonvolatile
memory locations.
1 Press Save/Recall
.
2 In the Save/Recall menu, select Storage until “Setups” is selected.
3 Press Setup to select the desired internal memory location.
4 Press Save or Load.