Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
A
101
Agilent 3000 Series Oscilloscopes
User’s and Service Guide
5
Saving, Recalling, and Printing Data
Saving and Recalling Waveforms and Setups 102
Saving to and Recalling from a USB Mass Storage Device 104
Printing the Display to a USB Printer 109
This chapter describes how to save, recall, and print data.
The oscilloscope has internal, nonvolatile memory locations for saving and
recalling waveforms and setups.
If the oscilloscope has the USB host port module attached to the rear
panel, you can:
• Save data to, and recall waveforms and setups from, a USB mass
storage device.
• Print to a USB printer.