Technical data
Table Of Contents
- Agilent 3000 Series Oscilloscopes-At a Glance
- In This Book
- Contents
- Figures
- Tables
- Getting Started
- Step 1. Inspect the package contents
- Step 2. Turn on the oscilloscope
- Step 3. Load the default oscilloscope setup
- Step 4. Input a waveform
- Step 5. Become familiar with the Front Panel Controls
- Step 6. Become familiar with the oscilloscope display
- Step 7. Use Auto-Scale
- Step 8. Compensate probes
- Step 9. Use the Run Control buttons
- Displaying Data
- Capturing Data
- Making Measurements
- Saving, Recalling, and Printing Data
- Oscilloscope Utility Settings
- Specifications and Characteristics
- Service
- Safety Notices
- Index
10 Agilent 3000 Series Oscilloscopes User’s Guide
Contents
6 Oscilloscope Utility Settings 111
Performing Mask Tests 112
To enable/disable mask tests 112
To select the source channel for mask tests 112
To run/stop a mask test 112
To turn on/off the mask test message display 113
To set the mask test output condition 113
To stop a mask test on the output condition 113
To set up masks 114
Setting IO Parameters 115
Setting the Menu Language 115
Turning Sound ON or OFF 116
Displaying System Information 116
Performing Self-Tests 117
To perform screen tests 117
To perform key tests 117
Running Self-Calibration 118
7 Specifications and Characteristics 119
Specifications 120
Characteristics 121
8Service127
Testing Performance 128
Before Testing Performance 129
Vertical Performance Verification 130
DC Gain Accuracy Test 130
Analog Bandwidth - Maximum Frequency Check 135
Performance Test Record 144