User`s guide

4-10

Printing, Plotting, and Saving Measurement Results

Conﬁguring a Plot Function

All copy conﬁguration settings are stored in non-volatile memory. Therefore, they are not

affected if you press or switch off the analyzer power.

Peripheral Interface Recommended Cables

Parallel 92284A

GPIB 10833A/33B/33D

Serial 24542G

1. Connect the peripheral to the interface port using the recommended cable from the

following list.

Figure 4-3 Peripheral Connections to the Analyzer

If You Are Plotting to an HPGL/2 Compatible Printer

2. Press and then press

until the correct printer choice appears:

❏ ThinkJet (QuietJet)

❏ DeskJet (This supports most current models such as DeskJet 890C, DeskJet 895C, or

DeskJet 1600C. See also DJ 540 selection.)

❏ LaserJet (only LaserJet models III, 4, 5, and 6)

❏ PaintJet

❏ Epson-P2 (printers that conform to the ESC/P2 printer control language, such as

Epson LQ-570)

❏ DJ 540 (This can be used for printers that do not support 100 dots per inch (dpi) but

do support 300 dpi such as the HP DeskJet 540 or 850C.)

Preset

Local

SET ADDRESSES

PRINTER PORT

PRNTR TYPE [ }