User`s guide

3-6 User’s and Service Guide

Controlling the Test Set and Making Measurements

Commands

To connect all ports to their internal 50 Ω loads, send the following two

commands:

NOTE When a test set port is not in use, it is terminated in 50 Ω.

If the 87050A Option K24 is being controlled by GPIB, you can read the

serial number of the test set by sending the following commands:

Reset Command:

When the Reset (*rst) command is sent, the box is set to a known state

where all ports are terminated.

OUTPUT 716;"PARAOUT24;"

OUTPUT 716;"PARAOUT49;"

OUTPUT 712;"*t_term"

OUTPUT 712;"*r_term"

OUTPUT 712;"sn?"

ENTER 712;Sn$

DISP Sn$