User`s guide

User’s and Service Guide 3-3
Controlling the Test Set and Making Measurements
Commands
Figure 3-1 Controlling the Test Set Over GPIB (HP-IB)
NOTE Connection to the network analyzer is not required when controlling
the test set over GPIB.
Network Analyzer Control
The third method of sending commands uses the network analyzer to
control the test set directly. This method is performed with the
standard setup of the network analyzer working with the test set. A
parallel cable is connected from the network analyzer output to the test
set input on both rear panels.
Press:
[SEQ]
TTL
→ I/O → PARALLEL ALL OUT
Use the arrow keys, ⇑ or ⇓, to scroll to the desired test port address, or
input the number directly using the hard keys
[D] → [x1], where D
represents the decimal value of the test port address (see Table 3-1 on
page 3-4).