Technical data

668 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
31 :WGEN Commands
For all waveform types, the output amplitude, into 50 Ω, can be adjusted
from 10 mVpp to 2.5 Vpp (or from 20 mVpp to 5 Vpp into and
open- circuit load).
Query Syntax
:WGEN:FUNCtion?
The :WGEN:FUNCtion? query returns the currently selected signal type.
Return Format
<signal><NL>
<signal> ::= {SIN | SQU | RAMP | PULS | NOIS | DC}
See Also • "Introduction to :WGEN Commands" on page 665
PULSe Use these commands to set the pulse signal parameters:
• ":WGEN:FREQuency" on page 666
• ":WGEN:PERiod" on page 686
• ":WGEN:VOLTage" on page 688
• ":WGEN:VOLTage:OFFSet" on page 691
• ":WGEN:VOLTage:HIGH" on page 689
• ":WGEN:VOLTage:LOW" on page 690
• ":WGEN:FUNCtion:PULSe:WIDTh" on page 669
The frequency can be adjusted from 100 mHz to 10 MHz.
The pulse width can be adjusted from 20 ns to the period minus 20 ns.
DC Use this command to set the DC level:
• ":WGEN:VOLTage:OFFSet" on page 691
NOISe Use these commands to set the noise signal parameters:
• ":WGEN:VOLTage" on page 688
• ":WGEN:VOLTage:OFFSet" on page 691
• ":WGEN:VOLTage:HIGH" on page 689
• ":WGEN:VOLTage:LOW" on page 690
Waveform
Type
Characteristics