Technical data

526 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide

25 :SBUS<n> Commands

:SBUS<n>:UART:TRIGger:DATA

(see page 790)

Command Syntax

:SBUS<n>:UART:TRIGger:DATA <value>

<value> ::= 8-bit integer from 0-255 (0x00-0xff) in decimal,

<hexadecimal>, <binary>, or <quoted_string> format

<hexadecimal> ::= #Hnn where n ::= {0,..,9 | A,..,F} for hexadecimal

<binary> ::= #Bnn...n where n ::= {0 | 1} for binary

<quoted_string> ::= any of the 128 valid 7-bit ASCII characters

(or standard abbreviations)

The :SBUS<n>:UART:TRIGger:DATA command selects the data byte value

(0x00 to 0xFF) for the trigger QUALifier when in UART mode. The data

value is used when one of the RD or TD trigger types is selected.

When entering an ASCII character via the quoted string, it must be one of

the 128 valid characters (case- sensitive): "NUL", "SOH", "STX", "ETX",

"EOT", "ENQ", "ACK", "BEL", "BS", "HT", "LF", "VT", "FF", "CR", "SO","SI",

"DLE", "DC1", "DC2", "DC3", "DC4", "NAK", "SYN", "ETB", "CAN", "EM", "SUB",

"ESC", "FS","GS", "RS", "US", "SP", "!", "\"", "#", "$", "%","&", "\'", "(", ")", "*", "+",

",", "- ", ".", "/","0", "1", "2", "3", "4", "5", "6", "7", "8", "9",":", ";", "<", "=", ">", "?",

"@", "A", "B", "C","D", "E", "F", "G", "H", "I", "J", "K", "L", "M","N", "O", "P", "Q",

"R", "S", "T", "U", "V", "W", "X", "Y", "Z","[", "\\", "]", "^", "_", "`", "a", "b", "c",

"d", "e", "f", "g", "h", "i", "j", "k", "l", "m", "n", "o", "p", "q", "r", "s", "t", "u", "v",

"w", "x", "y", "z", "{", "|", "}", "~", or "DEL".

Query Syntax

:SBUS<n>:UART:TRIGger:DATA?

The :SBUS<n>:UART:TRIGger:DATA? query returns the current UART

trigger data value.

Return Format

<value> ::= 8-bit integer in decimal from 0-255

See Also • "Introduction to :TRIGger Commands" on page 589

• ":TRIGger:MODE" on page 598

• ":SBUS<n>:UART:TRIGger:BASE" on page 524

• ":SBUS<n>:UART:TRIGger:TYPE" on page 529