Technical data

482 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide

25 :SBUS<n> Commands

:SBUS<n>:LIN:SAMPlepoint

(see page 790)

Command Syntax

:SBUS<n>:LIN:SAMPlepoint <value>

<value> ::= {60 | 62.5 | 68 | 70 | 75 | 80 | 87.5} in NR3 format

The :SBUS<n>:LIN:SAMPlepoint command sets the point during the bit

time where the bit level is sampled to determine whether the bit is

dominant or recessive. The sample point represents the percentage of time

between the beginning of the bit time to the end of the bit time.

Query Syntax

:SBUS<n>:LIN:SAMPlepoint?

The :SBUS<n>:LIN:SAMPlepoint? query returns the current LIN sample

point setting.

Return Format

<value> ::= {60 | 62.5 | 68 | 70 | 75 | 80 | 87.5} in NR3 format

See Also • "Introduction to :TRIGger Commands" on page 589

• ":TRIGger:MODE" on page 598

• ":SBUS<n>:LIN:TRIGger" on page 487

NOTE

The sample point values are not limited by the baud rate.