Technical data

:SBUS<n> Commands 25

Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 451

:SBUS<n>:MODE

(see page 790)

Command Syntax

:SBUS<n>:MODE <mode>

<mode> ::= {CAN | IIC | LIN | SPI | UART}

The :SBUS<n>:MODE command determines the decode mode for the serial

bus.

Query Syntax

:SBUS<n>:MODE?

The :SBUS<n>:MODE? query returns the current serial bus decode mode

setting.

Return Format

<mode> ::= {CAN | IIC | LIN | SPI | UART | NONE}

Errors • "- 241, Hardware missing" on page 753

See Also • "Introduction to :SBUS<n> Commands" on page 447

• ":SBUS<n>:CAN Commands" on page 452

• ":SBUS<n>:IIC Commands" on page 469

• ":SBUS<n>:LIN Commands" on page 479

• ":SBUS<n>:SPI Commands" on page 493

• ":SBUS<n>:UART Commands" on page 509

NOTE

This command is only valid when a serial decode option has been licensed.