Technical data

s1
411
Agilent InfiniiVision 2000 X-Series Oscilloscopes
Programmer's Guide
22
:POD Commands
Control all oscilloscope functions associated with groups of digital
channels. See "Introduction to :POD<n> Commands" on page 411.
Introduction to
:POD<n>
Commands
<n> ::= 1
The POD subsystem commands control the viewing and threshold of
groups of digital channels.
POD1 ::= D0- D7
Reporting the Setup
Use :POD1? to query setup information for the POD subsystem.
Return Format
The following is a sample response from the :POD1? query. In this case,
the query was issued following a *RST command.
:POD1:DISP 0;THR 1.40E+00
Table 72 :POD<n> Commands Summary
Command Query Options and Query Returns
:POD<n>:DISPlay {{0 |
OFF} | {1 | ON}} (see
page 412)
:POD<n>:DISPlay? (see
page 412)
{0 | 1}
<n> ::= 1 in NR1 format
:POD<n>:SIZE <value>
(see page 413)
:POD<n>:SIZE? (see
page 413)
<value> ::= {SMALl | MEDium |
LARGe}
:POD<n>:THReshold
<type>[suffix] (see
page 414)
:POD<n>:THReshold?
(see page 414)
<n> ::= 1 in NR1 format
<type> ::= {CMOS | ECL | TTL |
<user defined value>}
<user defined value> ::= value in
NR3 format
[suffix] ::= {V | mV | uV }
NOTE
These commands are only valid for the MSO models.