Technical data

What's New 1
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 37
Discontinued
Commands
Command Description
:ACQuire:RSIGnal The 2000 X-Series oscilloscope does not have a 10 MHz REF
BNC connector.
:CALibrate:SWITch? Replaced by :CALibrate:PROTected? (see page 212). The
oscilloscope has a protection button instead of a switch.
:DISPlay:SOURce PMEMory (pixel memory) locations are not present.
:EXTernal:IMPedance External TRIG IN connector is now fixed at 1 MOhm.
:EXTernal:PROBe:ID Not supported on external TRIG IN connector.
:EXTernal:PROBe:STYPe Not supported on external TRIG IN connector.
:EXTernal:PROTection Not supported on external TRIG IN connector.
:HARDcopy:DEVice,
:HARDcopy:FORMat
Use the :SAVE:IMAGe:FORMat, :SAVE:WAVeform:FORMat, and
:HARDcopy:APRinter commands instead.
:MERGe Waveform traces have been replaced by reference waveforms.
:RECall:IMAGe[:STARt] Waveform traces have been replaced by reference waveforms.
:SYSTem:PRECision The 2000 X-Series oscilloscopes' measurement record, and
maximum record size, is 62,500 points, and there is no need for a
special precision mode.
:TIMebase:REFClock The 2000 X-Series oscilloscope does not have a 10 MHz REF
BNC connector.