Technical data

348 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide

20 :MEASure Commands

Vtop. If you want to move the delay measurement point nearer to Vtop or

Vbase, you must change the threshold values with the :MEASure:DEFine

THResholds command.

Return Format

<value> ::= floating-point number delay time in seconds in NR3 format

See Also • "Introduction to :MEASure Commands" on page 340

• ":MEASure:DEFine" on page 344

• ":MEASure:PHASe" on page 356