Technical data

32 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
1 What's New
What's New in Version 1.20
New features in version 1.20 of the InfiniiVision 2000 X- Series oscilloscope
software are:
• X cursor units that let you measure time (seconds), frequency (Hertz),
phase (degrees), and ratio (percent), and Y cursor units that let you
measure the channel units (base) or ratio (percent).
• Option for specifying FFT vertical units as V RMS as well as decibels.
• Option for saving the maximum number of waveform data points.
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command Description
:FUNCtion[FFT]:VTYPe (see page 283) Specifies FFT vertical units as DECibel or
VRMS.
:MARKer:XUNIts (see page 325) Specifies the units for X cursors.
:MARKer:XUNIts:USE (see page 326) Sets the current X1 and X2 cursor locations as
0 and 360 degrees if XUNIts is DEGRees or as 0
and 100 percent if XUNIts is PERCent.
:MARKer:YUNIts (see page 330) Specifies the units for Y cursors.
:MARKer:YUNIts:USE (see page 331) Sets the current Y1 and Y2 cursor locations as
0 and 100 percent if YUNIts is PERCent.
:SAVE:WAVeform:LENGth:MAX (see page 442) Enable or disables saving the maximum
number of waveform data points.
:TRIGger:FORCe (see page 592) Now documented, this command is equivalent
to the front panel [Force Trigger] key which
causes an acquisition to be captured even
though the trigger condition has not been met.