Technical data

28 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
1 What's New
What's New in Version 2.20
New features in version 2.20 of the InfiniiVision 2000 X- Series oscilloscope
software are:
• Support for modulation of the waveform generator output.
• Support for controlling the optional DSOXDVM digital voltmeter analysis
feature
• Ability to turn reference waveform locations on or off and view their
status using the :VIEW, :BLANk, and :STATus commands.
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command Description
:DVM Commands (see page 263) Commands for controlling the optional
DSOXDVM digital voltmeter analysis feature.
:WGEN:MODulation:AM:DEPTh (see page 672) Specifies the amount of amplitude modulation.
:WGEN:MODulation:AM:FREQuency (see
page 673)
Specifies the frequency of the modulating
signal.
:WGEN:MODulation:FM:DEViation (see
page 674)
Specifies the frequency deviation from the
original carrier signal frequency.
:WGEN:MODulation:FM:FREQuency (see
page 675)
Specifies the frequency of the modulating
signal.
:WGEN:MODulation:FSKey:FREQuency (see
page 676)
Specifies the "hop frequency".
:WGEN:MODulation:FSKey:RATE (see
page 677)
Specifies the rate at which the output
frequency "shifts".
:WGEN:MODulation:FUNCtion (see page 678) Specifies the shape of the modulating signal.
:WGEN:MODulation:FUNCtion:RAMP:SYMMet
ry (see page 679)
Specifies the amount of time per cycle that the
ramp waveform is rising.
:WGEN:MODulation:STATe (see page 681) Enables or disables modulated waveform
generator output.
:WGEN:MODulation:TYPE (see page 682) Selects the modulation type: Amplitude
Modulation (AM), Frequency Modulation (FM),
or Frequency-Shift Keying Modulation (FSK).