Technical data

26 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
1 What's New
What's New in Version 2.30
New features in version 2.30 of the InfiniiVision 2000 X- Series oscilloscope
software are:
• Support for CAN/LIN, I2C/SPI, and UART/RS232 serial triggering and
decode.
• Saving Multi Channel Waveform data (*.h5) format files that can be
opened by the N8900A InfiniiView oscilloscope analysis software.
More detailed descriptions of the new and changed commands appear
below.
New Commands
Command Differences
:LISTer Commands (see
page 313)
Commands for turning on/off the serial decode Lister display
and returning data from the Lister display.
:SAVE:LISTer[:STARt] (see
page 434)
Saves the Lister display data to a file.
:SAVE:MULTi[:STARt] (see
page 436)
Lets you save Multi Channel Waveform data (*.h5) format files
that can be opened by the N8900A InfiniiView oscilloscope
analysis software.
:SBUS<n>:CAN Commands
(see page 452)
Commands for CAN triggering and serial decode.
:SBUS<n>:DISPlay (see
page 450)
Turns serial decode ON or OFF.
:SBUS<n>:IIC Commands (see
page 469)
Commands for IIC triggering and serial decode.
:SBUS<n>:LIN Commands
(see page 479)
Commands for LIN triggering and serial decode.
:SBUS<n>:MODE (see
page 451)
Selects the type of serial decode.
:SBUS<n>:SPI Commands
(see page 452)
Commands for SPI triggering and serial decode.
:SBUS<n>:UART Commands
(see page 509)
Commands for UART/RS232 triggering and serial decode.
:SEARch:COUNt (see
page 533)
Returns the number of search events found.
:SEARch:MODE (see
page 534)
Can select SERial1.
:SEARch:SERial:CAN
Commands (see page 536)
Commands for finding CAN events in the captured data.