Technical data

:CHANnel<n> Commands 10

Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 235

:CHANnel<n>:UNITs

(see page 790)

Command Syntax

:CHANnel<n>:UNITs <units>

<units> ::= {VOLT | AMPere}

<n> ::= 1 to (# analog channels) in NR1 format

The :CHANnel<n>:UNITs command sets the measurement units for the

connected probe. Select VOLT for a voltage probe and select AMPere for a

current probe. Measurement results, channel sensitivity, and trigger level

will reflect the measurement units you select.

Query Syntax

:CHANnel<n>:UNITs?

The :CHANnel<n>:UNITs? query returns the current units setting for the

specified channel.

Return Format

<units> ::= {VOLT | AMP}

See Also • "Introduction to :CHANnel<n> Commands" on page 218

• ":CHANnel<n>:RANGe" on page 233

• ":CHANnel<n>:PROBe" on page 227

• ":EXTernal:UNITs" on page 275