Technical data

154 Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide
6 Root (:) Commands
For further information on :AUToscale, see the User's Guide.
See Also • "Introduction to Root (:) Commands" on page 150
• ":AUToscale:CHANnels" on page 156
• ":AUToscale:AMODE" on page 155
Example Code
' AUTOSCALE - This command evaluates all the input signals and sets
' the correct conditions to display all of the active signals.
myScope.WriteString ":AUToscale" ' Same as pressing Auto Scale key.
See complete example programs at: Chapter 38, “Programming Examples,”
starting on page 799