Technical data

Common (*) Commands 5
Agilent InfiniiVision 2000 X-Series Oscilloscopes Programmer's Guide 125
*CLS (Clear Status)
(see page 790)
Command Syntax
*CLS
The *CLS common command clears the status data structures, the
device-defined error queue, and the Request- for-OPC flag.
See Also • "Introduction to Common (*) Commands" on page 123
• "*STB (Read Status Byte)" on page 142
• "*ESE (Standard Event Status Enable)" on page 126
• "*ESR (Standard Event Status Register)" on page 128
• "*SRE (Service Request Enable)" on page 140
• ":SYSTem:ERRor" on page 567
NOTE
If the *CLS command immediately follows a program message terminator, the output queue
and the MAV (message available) bit are cleared.