User`s manual
Acquisition modes
Normal
Peak detect Capture glitch as narrow as 500 ps at all timebase settings.
Averaging Select from 2,4,8,16, 64... to 65,536
High resolution mode 12 bits of resolution when ≥ 20 µs/div
Segmented Re‑arm time= 19 µs (minimum time between trigger events)
Trigger system
Trigger modes
– Normal (triggered): requires trigger event for scope to trigger
– Auto: triggers automatically in absence of trigger event
– Single: triggers only once on a trigger event, press [Single] again for scope to nd another trigger
event, or press [Run] to trigger continuously in either Auto or Normal mode
– Force: front panel button that forces a trigger
Trigger coupling Coupling selections: AC, DC, noise reject, LF reject and HF reject.
Trigger source Each analog channel, each digital channel (MSO models or DSOX2MSO upgrade, Ext, WaveGen, line)
Trigger sensitivity (internal)* < 10 mV/div: greater of 1 div or 5 mV; ≥ 10 mV/div: 0.6 div
Trigger sensitivity (external)* 200 mV (DC to 100 MHz); 350 mV (100 MHz ‑ 200 MHz)
External trigger input Included on all models
Trigger type selections
All 2000 X-Series models
Edge Trigger on a rising, falling, alternating or either edge of any source
Pulse width Trigger on a pulse on a selected channel, whose time duration is less than a value, greater than a value,
or inside a time range
– Minimum duration setting: 2 ns- 10 ns (depends on bandwidth)
– Maximum duration setting: 10 s
Pattern Trigger when a specified pattern of high, low, and don’t care levels on any combination of analog, digital,
or trigger channels is [entered | exited]. Pattern must have stabilized for a minimum of 2 ns to qualify as
a valid trigger condition.
Video Trigger on all lines or individual lines, odd/even or all fields from composite video, or broadcast
standards (NTSC, PAL, SECAM, PAM‑M)
I²C (optional) Trigger on I²C (Inter‑IC bus) serial protocol at a start/stop condition or user defined frame with address
and/or data values. Also trigger on missing acknowledge, address with no accq, restart, EEPROM read,
and 10‑bit write.
SPI (optional) Trigger on SPI (Serial Peripherial Interface) data pattern during a specific framing period. Supports positive
and negative Chip Select framing as well as clock Idle framing and userspecified number of bits per frame.
CAN (optional) Trigger on CAN (controller area network) version 2.0A and 2.0B signals. Trigger on the start of frame
(SOF) bit (standard). Remote frame ID (RTR), data frame ID (~RTR), remote or data frame ID, data frame
ID and data, error frame, all errors, acknowledge error and overload frame.
LIN (optional) Trigger on LIN (Local Interconnect Network) sync break, sync frame ID, or frame ID and data.
RS232/422/485/UART
(optional)
Trigger on Rx or Tx start bit, stop bit or data content
Performance characteristics (continued)
* Denotes warranted specications, all others are typical.
Specications are valid after a 30-minute warm-up period and from ±10 °C rmware calibration temperature.
16 | Keysight | InniiVision 2000 X-Series Oscilloscopes - Data Sheet