Technical data

1 Specifications
2 N1911A/1912A P-Series Power Meters Service Guide
Introduction
This chapter details the power meter’s specifications and supplemental
characteristics
Specifications describe the warranted performance and apply after a 30
minute warm- up. These specifications are valid over the power meter’s
operating and environmental range unless otherwise stated and after
performing a zero and calibration.
Supplemental characteristics, which are shown in italics, are intended to
provide information useful in applying the power meter by giving typical,
but non warranted performance parameters. These characteristics are
shown in italics or denoted as “attributes”, “nominal” or “approximate”.
For information on measurement uncertainty calculations, refer to
Keysight Application Note 64- 1A, “Fundamentals of RF and Microwave
Power Measurements”, Literature 5965- 6630E.