Technical data

6Repair Guide
90 N1911A/1912A P-Series Power Meters Service Guide
• Remove DAP/PPMC (Figure 6-12): Use the
T8 Torx screwdriver bit to remove the
screws attaching the DAP and PPMC
assemblies to the main board. Carefully
remove the PPMC assembly by lifting the
end closest to the DAP assembly. Carefully
remove each DAP assembly by lifting the
end closest to the rear panel.
Figure 6-12
• Remove the main board (Figure 6-13): Use
the T20 Torx screwdriver bit to remove the 5
screws attaching the main board to the
bottom clamshell. Use the T20 Torx
screwdriver bit to remove the screw
attaching the earth wires to the line module.
Remove the earth wires and washers,
taking note of the assembly order. Lift &
remove the main board.
Figure 6-13
Instructions Visual