Technical data

SERVice Subsystem 16
N1911A/1912A P-Series Power Meters Programming Guide 719
SERVice:SENSor[1]|2:CORRections:STATe <boolean>
This command enables/disables the voltage to corrected power conversion.
It applies to E9320 Series and P- Series power sensors only.
Syntax
Example
Reset Condition
On reset, the value is set to ON.
NOTE
Before setting this command to OFF, you must set the INIT:CONT command to OFF.
After setting this command to OFF, you must only run commands relating to the gathering
of ADC values—for example, the SERV:SENS:RADC command.
SERV:SENS2:CORR:STAT ON This command enables the voltage to
corrected power conversion for Channel
B.
0|OFF
1|ON
Space
?
:STAT
:CORR
SERV
1
2
:SENS