Technical data

12 SYSTem Subsystem
500 N1911A/1912A P-Series Power Meters Programming Guide
SYSTem:COMMunicate:LAN:CURRent:SMASk?
This command returns the current setting of the LAN subnet mask in use
by the power meter.
Syntax
Example
NOTE
If DHCP or AutoIP are successfully enabled, then one of these IP address modes assign the
LAN subnet mask, otherwise it is the static LAN subnet mask.
SYST
:COMM
:CURR
:SMAS
?
:LAN
SYST:COMM:LAN:CURR:SMAS? This command queries the current setting
of the LAN subnet mask.