Technical data

Power Meter Remote Operation 1
N1911A/1912A P-Series Power Meters Programming Guide 5
Introduction
This chapter describes the parameters which configure the power meter
and help you determine settings to optimize performance. It contains the
following sections:
• “Configuring the Remote Interface” on page 6.
• “Zeroing and Calibrating the P- Series Power Sensor” on page 9.
• “Making Measurement” on page 11.
• “Using Frequency Dependent Offset Tables” on page 27.
• “Setting the Range, Resolution and Averaging” on page 34.
• “Setting Offsets” on page 38.
• “Setting Measurement Limits” on page 40.
• “Getting the Best Speed Performance” on page 44.
• “How Measurements are Calculated” on page 49.
• “Status Reporting” on page 50.
• “Saving and Recalling Power Meter Configurations” on page 69.
• “Using Device Clear to Halt Measurements” on page 70.
• “An Introduction to the SCPI Language” on page 71.
• “SCPI Compliance Information” on page 81.
• “Summary of Commands” on page 83.
• “Making Measurements on Wireless Communication Standards” on
page 84.