Technical data

7MEMory Subsystem
286 N1911A/1912A P-Series Power Meters Programming Guide
Query Example
Error Messages
• If more than 81 calibration factors for sensor calibration tables, or 80
offsets for frequency dependent offset tables are in the list, error –108,
“Parameter not allowed” occurs.
• If a table is not specified using the MEMory:TABLe:SELect command,
the data cannot be entered and error –221, “Settings conflict” occurs.
• If any of the calibration/offset factors are outside of the allowed range,
error –222, “Data out of range” occurs.
MEM:TABL:GAIN? This command queries the calibration
factor/offset in the current table.