Technical data

CALCulate Subsystem 3

N1911A/1912A P-Series Power Meters Programming Guide 193

CALCulate[1]|2|3|4:PHOLd:CLEar

This command clears the peak hold value for a specified CALC block so

that a new peak hold value can be set.

Syntax

Example

Error Messages

• If no power sensor is connected, error –241 “Hardware missing” occurs.

• If a sensor, other than an P- Series or E9320 power sensor, is

connected, error –241 “Hardware missing” occurs.

•If SENS:DET:FUNC is set to AVER or TRIG:SOUR is set to INT1, INT2 or

EXT, error –221 “Settings conflict” occurs.

NOTE

Clearing the peak hold value for a specified CALC block may affect the peak hold value of

other CALC blocks, depending on the CALC channel set up (set by CALC:MATH:EXPR).

CALC2:PHOLd:CLEar This command clears the peak hold value

for CALC2.

:PHOL

:CLE

CALC